This page contains Drafts Specifications currently under review.
Please note:
* The Rotating Machines Working Group are not the authors of these specifications.
* Please note that these specifications are for the express use of the Rotating Machines Working Group Members. Many of these documents are password protected. The password will only be sent to boni fide RMWB members.
* The RMWG cannot accept any responsibility for any of the contents of these specifications.
* These specifications have not been issued for use, and as such should not be used as official specifications.
* The express purpose of hosting these specifications is to allow the industry easy access to them in order the provide relevant feedback to the certification bodies.
* Should you which to send your comments, please send us a note on the Contact Us page, and we will forward you the contact details of the certification body.
| IEC 60034-22 Ed. 2.0:2010: (Draft of 2009-12-08): SANS 60034-22, Rotating electrical machines Part 22: AC generators for reciprocating internal combustion (RIC) engine driven generating sets |
| |
 |
| IEC 60034-30 Ed. 1.0:2008: (Draft of 2008/03/14): IEC 60034-30: Rotating electrical machines - Part 30: Efficiency classes of single-speed, three-phase, cage-induction motors (IE-code) |
| |
 |
| IEC 60034-3 Ed. 3:2008: Rotating electric machines - Part 3: Part 3: Specific requirements for synchronous
generators driven by steam turbines or
combustion gas turbines. |
| |
|
| IEC 60034-2-1 Ed. 1: Rotating electric machines - Part 2-1: Standard methods for determining losses and efficiency from tests (excluding machines for traction vehicles.) |
| |
|
| IEC 60034-15 Ed. 3.0: Rotating electric machines - Part 15: Impulse voltage withstand levels of form wound
stator coils for rotating a.c. machines |
| |
|
| SANS 60034-2-1 Ed. 1: Rotating electric machines - Part 2-1: Standard methods for determining losses and efficiency from tests (excluding machines for traction vehicles.) |
| |
|
| SANS 60034-14: Rotating electrical machines Part 14: Mechanical vibration of certain machines with shaft
heights 56 mm and higher - Measurement, evaluation and limits of vibration severity.
Proposed amendment number: Amendment 1:2007 |
| |
|
SANS 60034-16-1: Excitation systems for
synchronous machines.
Chapter 1: Definitions.
Proposed correction 1: 2007 |
| |
- Proposal
- Document |
| SANS 60034-25: Rotating electrical machines Part 25: Guide for the design and performance of cage
induction motors specifically designed for converter supply |
| |
|
| IEC 60034-27: Rotating machines - Off-line partial discharge measurements on the stator winding insulation of rotating electrical machines. |
| |
|
| SANS 1561-1: 2006: Edition 2: Rewound and refurbished rotating electrical machines: Part 1: Low-voltage three-phase induction motors |
| |
|
| SANS 1804-1: 2007: Edition 2: Induction motors Part 1: IEC requirements |
| |
|
| SANS 1804-2: 2007: Edition 1.4: Part 2: Low-voltage three-phase
standard motors |
| |
|
| SABS 0542-1: 1999: Edition 1.4: The rewinding and refurbishing of rotating
electrical machines:
Part 1: Low-voltage three-phase induction
motors |
| |
|
.
